Kartier Pohs

Saturday, September 12, 2015

How To Change Your Ip In Less Than 1 Minute

IP stands for Internet protocol.It is basically an identification of a particular computer on the Internet.There are two type of IP addresses.Static IP and Dynamic IP.It depends on the Internet Service Provider and basically they provide us a dynamic IP but if we want a static IP then we can request for it also.
As the name suggest static and dynamic we can get its meaning.Static IP is the ip which never changed and dynamic ip is the ip which get change every time we connect/disconnect the internet connection.
How To Change Your Ip In Less Than 1 Minute

Sometime we need to change our ip for security purpose in that case it takes too much time to change IP.But here i am going to show you a technique by which you can Change Your IP Within 1 Minute.
So just follow these basic steps and Change Your IP Within 1 Minute.

1. Click on "Start" in the bottom left hand corner of screen
2. Click on "Run"
3. Type  "cmd" and hit ok
 

How To Change Your Ip In Less Than 1 Minute

 Now you will be at an MSDOS prompt screen.

4. Type "ipconfig /release" just like that, and hit "enter"
5. Type "exit" and leave the prompt

6. Right-click on "Network Places" or "My Network Places" on your desktop.
7. Click on "properties"
 

Now you will be on a screen with something titled "Local Area Connection", or something close to that, and, if you have a network hooked up, all of your other networks.

8. Right click on "Local Area Connection" and click "properties"
9. Double-click on the "Internet Protocol (TCP/IP)" from the list under the "General" tab
10. Click on "Use the following IP address" under the "General" tab
11. Create an IP address (It doesn't matter what it is. I just type 1 and 2 until i fill the area up).

12. Press "Tab" and it should automatically fill in the "Subnet Mask" section with default numbers.
13. Hit the "Ok" button here
14. Hit the "Ok" button again

You should now be back to the "Local Area Connection" screen.

15. Right-click back on "Local Area Connection" and go to properties again.
16. Go back to the "TCP/IP" settings
17. This time, select "Obtain an IP address automatically"
tongue.gif 18. Hit "Ok"
19. Hit "Ok" again
20. You now have a new IP address


Note:This only changes your dynamic IP address, not your ISP/IP address. If you plan on hacking a website with this trick be extremely careful, because if they try a little, they can trace it back.

3 comments:

  1. I tell you a way to do it in 10 seconds.

    Opena command line prompt (CMD.EXE) and type

    IPCONFIG /RELEASE
    IPCONFIG /RENEW

    ReplyDelete

Copyright 2015 @ Yogesh Prasad